Preventing corrosion on fittings and Tanks
Protection for sensitive connections
In distribution stations of energy plants and in gas compression stations, valves, flanges and fittings connect the pipelines. In refineries, liquids or gases are stored in above-ground tanks, whose leakage must be reliably prevented.
These sensitive connections must be permanently protected against corrosion without impairing their functionality, while still allowing routine maintenance.
Optimum balance between strength and flexibilityDENSOLID®-FK2 gives outstanding protection against corrosion in the sensitive areas around connections, providing an optimum balance between flexibility and hardness. DENSOLID®-FK2 is a solvent-free coating that can be applied at the factory or on the construction site.
Easy maintenance for maximum cost efficiencyCavities and uneven surfaces around fittings and flanges are high-maintenance areas – so reliable corrosion prevention is essential. For almost a century, these kinds of connections have been protected by DENSO® petrolatum tapes and mastics.
Permanent sealing in the transition area between steel and concrete
Above-ground storage tanks are often exposed to high levels of corrosion: This is because air and water can penetrate through small gaps between the concrete base and steel plate. These corrosive media endanger the tanks, in the worst case they will get defective and have to be replaced at high cost. The DENSO®-TB System is a highly effective corrosion protection and at the same time a permanent seal for the transition area between steel and concrete. You simply apply the solvent-free product without drying or preheating, as it is even suitable for damp surfaces. Even with tank movements and temperature changes, the system remains flexible and adaptable.